FasTrac CE408 GOLD Anchoring Adhesive is a two-component, 100% solids, moisture-insensitive, high-strength, high-modulus, non-sag epoxy acrylate anchoring adhesive.
FasTrac CE408 GOLD is compliant with the following codes and standards:
2018-2006 International Building Code (IBC)
2018-2006 International Residential Code (IRC)
ACI 318-14, ACI 318-11
Use for installation of reinforcing steel, and threaded rods in dry, damp or water saturated cracked and uncracked concrete in vertical downward, horizontal, upwardly inclined and overhead post installed anchoring applications.
May be used for sustained and short term loads including seismic loads (categories A-F) and wind loads.
Installation Temperature 14°F - 95°F
High Strength, High Modulus
Non-Sag Gel Consistency
Low VOC, Low Odor
Where To Use
Use for installation of reinforcing steel and threaded rods
Dry, damp or water-saturated concrete
Cracked and uncracked concrete applications
Vertical downward, horizontal, upward inclined and overhead post-installed anchoring applications
Sustained and short-term loads
Seismic loads (categories A-F)
Mix Ratio: 10:1
Viscosity: 1/4 inch non-sag gel
Get Time: 5 minutes (60g @ 73F)
Tensile Strength: 3,500 psi
Compressive Strength: >10,000 psi (7 day)
300 ml cartridge
825 ml cartridge
12 months in original unopened container
Store at 40F-77F (5C-25C)
Application Temperature Range
Pre-condition CE408 GOLD to 65°F – 85°F ( 18-29°C) for optimum application. Minimum substrate temperature is 14°F ( -10°C).
With more than 30 years experience in developing and manufacturing cutting edge products, FasTrac Construction Products are known for performance and consistency. When combined with our commitment to excellent customer service you have a winning combination that brings value to the construction industry.